Hogar / productos / Pintura de polvo de poliéster epoxi / Tiny Textured/Structure Epoxi Poliéster Hybid Pinturs En Polvo Revestimiento en polvo

loading

Compartir con:
facebook sharing button
twitter sharing button
line sharing button
wechat sharing button
linkedin sharing button
pinterest sharing button
sharethis sharing button

Tiny Textured/Structure Epoxi Poliéster Hybid Pinturs En Polvo Revestimiento en polvo

Tiny Textured/Structure Epoxy Polyester Hybid Pinturs En Polvo Powder Coating
Pinturs En Polvo  Powder Coating 



1.General introduction:

  Powder coatings are mixed with a certain proportion of the resin, fillers, curing agents and other additives, then prepared by hot extrusion ,crushed  and sieved.The products are stable at room temperature storage, then baking heat melted and solidified to form a smooth and bright permanent coating to achieve the purpose of decoration and corrosion.
 
2.Feature:
           
1).The products are non-toxic, solvent-free and non-toxic volatile substances,
there are no intoxication, no fire, no "three wastes" emissions and other pollution problems, in full compliance with national environmental laws. 
2).Raw material utilization is high, the highest utilization rate even more than
99%. 
3).After being pre-coated handle, disposable construction, without primer,
you can get a sufficient thickness of the coating, easy to automate operation, high production efficiency, reduce costs. 
4).Dense coating adhesion, good impact strength and toughness, high
coverage corners, with excellent resistance to chemical corrosion and electrical insulation properties. 
5).Powder coatings storage and transport are safety and convenience.
   
3.Product series: 
   
  The products include high light ( above 86%),glazed (76%-85%),matte(20%-50%),low light (below 20%). We also offer a variety of shiny products according to the needs of users.
 
4.Powder physical properties: 
 
   Proportion : 1.2-1.8 (depending on the color and gloss ) .
 
   Particle size distribution: 100% less than 125 microns (more than 85%          
   between 60 to 90).

   Liquidity(180°C):22~35mm.

   Curing conditions:200°C,10 minutes.


 
Estado de Disponibilidad:
Cantidad:
  • Recubrimiento en polvo de poliéster epoxi texturizado/estructurado minúsculo

  • FEIHONG

Product Description

Capa texturizada minúscula del polvo de Hybid Pinturs En Polvo del poliéster de epoxy de la estructura

Anterior: 
Siguiente: